SMR Gearbox Set up
Satisfactory performance is dependent upon correct set up. lubrication and maintenance. consequently it’s important that the directions within the set up and upkeep leaflet. supplied with each gearbox. are followed very carefully. a few of the 
essential elements of belt and torque-arm set up are listed beneath.
1. Install pulley on gearbox input shaft as close to your reducer achievable, and mount reducer on driven shaft as shut to bearing as practical. failure to complete this will likely trigger excess loads in the input shaft bearings and output bearings and could lead to their premature failure.
2. Install motor and wedge belt drive using the belt pull at roughly 90° for the center line among driven and input shafts. this will likely permit tensioning with the wedge belt drive together with the torque arm which should really preferably be in tension. if output hub runs anti-clockwise. torque arm needs to be positioned the ideal.
three. lnstall torque-arm fulcrum on a rigid support so that the torque-arm might be at approximately proper angles on the center line through the driven shaft and the torque arm situation bolt. ensure there exists enough consider up from the turnbuckle for belt tension adjustment.
Maintain near.
Bell drive may very well be located in any handy postion. in case the torque arm is usually to be utilised to tighten the belts, the drive needs to be at about tight angle to your line in between the input and output shafts.
Bell drive may be found for the appropriate if sought after.
If output hub rotates clock-wise. position belt drive and torque arm in opposite route to that proven in the illustration.
Torque arm and belt consider up.
Torque arm could possibly be mounted for the right if wanted.
