Power UNITS FOR LIFT TABLE 1
General Description
This energy unit is intended exclusively for that smaller lift table,Consisting of large pressure gear pump, AC motor, multi-functional manifold, valves, tank, and so forth. This energy unit has been widely employed within the sector of logistic products which include minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed through the solenoid valve with all the speed controlled by the adjustable needle valve.
Power UNITS FOR LIFT TABLE two
Basic Description
This energy unit is designed exclusively for the medium lift table, Consisting of highly effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The lowering motion is actived through the solenoid valve as well as pace managed from the adjustable needle valve. Once the lift rises to a high positoin, but the electrical power supply is minimize, the reducing movement is controlled through the manual override function.
Electrical power UNITS FOR LIFT TABLE 
3
Common Description
This power unit is designed solely to the large lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived through the solenoid valve and the velocity managed by a stress compensated flow control valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This electrical power unit is designed solely to the massive lift table, Consisting of really effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve along with the velocity controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the power provide is minimize, the decreasing motion is controlled from the manual override function.
Particular Notes
1. This power unit is of S3 duty cycle, which can only get the job done intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean all of the hydraulic elements concerned just before installation of the electrical power unit.
3. Viscosity of your oil shoud be 15~46 cst,which need to also be clean and totally free of impurities.N46 hydraulic oil is suggested.
four. Oil altering is required soon after the original 100 operation hours,afterwards once just about every 3000 hours.
five. The electrical power unit shown is designed to be mounted vertically.
