C Variety Flex-Flex Couplings
The C Form coupling includes two flex hubs, 1 sleeve and a single accessory kit consisting of seals and snap rings.
CFR Kind Flex-Rigid Couplings
The CFR Kind coupling include one particular flex hub, one rigid hub, a single sleeve, one accessory kit consisting of seals and snap rings.
Characteristics
Simple and low-cost style of gear coupling
All steel sleves and hubs
Reinforced rubber seals with snap rings to hold lubricant in location
Offered as vertical and horizontal couplings
Broad assortment of specific variations which include full-flex, flex-rigid mill motor
Typical configurations can be found of the shelf
Ordering Information and facts
Application: Driver and Driven.
Type and size of coupling, horizontal, vertical and so forth.
Electrical power: Motor horspower or torque necessity.
Speed: Motor RPM or Driven RPM.
Distance amongst shaft ends (BSE).
Shaft sizes.
C and CFR Sort Couplings
Ordering Information
Puller Holes are standard on sizes four by 12.
Puller Holes are available for sizes 7/8 through three.five at an extra charge.
The BSE (distance Amongst Shaft Ends) may well differ amongst G and G1.
Interference bores without set screws are standard unless of course otherwise specified.
Inch bores and keyway tolerances conform to 
ANSI / AGMA 9002-B04.
For metric bores and keyway tolerances, seek advice from Engineering Part.
Greater sizes can be found, please seek advice from Technical Support.
